Aspire Rover 2 Kit
Aspire Rover 2 Kit
£47.99

Product Info

This kit is a perfect starter device or first time upgrade device. Aspire are known for reliable production quality and sensible designs that deliver good flavour and a simple, easy to use vaping experience.

This device is particularly well suited to use with Nicotine Salts based E Liquids

Set up procedure

Filling The Tank For The First Time

The most important thing to do when first setting up this kit is to open the tank from the top by unscrewing the top cap and drip tip assembly, and check to make sure the coil is tightly screwed into the base.

This is often not checked at the factory. If the coil is not tight into the base liquid will leak through into the base of the tank causing issues with the connection to the NX40 device which may start to produce short circuit readings.

Once the coil is seated securely you can go ahead and fill the tank and allow it 5 minutes to stand and wick prior to use. Or take a moment to prime the cotton inside the coil with e liquid until the cotton is moist throughout . Then proceed to filling the tank.

Once filling is completed , seat the tank onto the mod and screw into place taking care not to cross thread or force the threads in any way. Screw the tank down until it it "finger tight" only.

Press the power button on NX40 the device 5 times rapidly within a 2 second window to turn it on.

Set the power level to within the range specified on the coil you have elected to use. This can be found printed on the coil itself example: 7w -15w means 7 watts minimum up to 15 watts maximum.

Do not exceed the maximum watts rating for your coil. This will cause irreversible damage to the cotton wicks which will result in having to replace the coil.

Aspire Rover 2 Kit

Hardware Accessories

Aspire NAUTILUS COIL
Aspire NAUTILUS COIL
£2.99
Aspire NX40 Mod
Aspire NX40 Mod
£35.99

Manufactures Guide

PDF
Aspire Rover 2 kit User Manual English
Wed 02 Sep 2020
Download Download

Troubleshooting

  • Common IssuesShow

    Short or 0.00 Ohms readings from the device / Low Load

    • The most important thing to do when first setting up this kit is to open the tank from the top by unscrewing the top cap and drip tip assembly, and check to make sure the coil is tightly screwed into the base.
      This is often not checked at the factory. If the coil is not tight into the base liquid will leak through into the base of the tank causing issues with the connection to the NX40 device which may start to produce short circuit readings. Which will prevent the NX40 device from firing the coil to produce Vapour.
      Once the coil is seated securely you can go ahead and fill the tank and allow it 5 minutes to stand and wick prior to use. Or take a moment to prime the cotton inside the coil with e liquid until the cotton is moist throughout . Then proceed to filling the tank.
    • If the above does not resolve the short reading try a spare coil . If the spare works then it's likely the first coil had some sort of manufacturer flaw.