The Innokin EQ Pod Starter Kit is the first pod system to use 0.5 ohm MTL (Mouth to lung) mesh coils. The pods have a 2ml capacity and due to the ultra fast wicking and the coils eliminating the chance of a hotspot, so no more spitting. It’s refillable and offers unmatched flavour in its class.
How Does It Work?
The Innokin EQ uses a 3 click on and off function. To fill the pod, it is removed my pulling upwards and twisting the base of the pod to revel two juice filling holes. Fill this and close the base again. Allow to sit for a minute before vaping. To change between high and low power function turn off device and hold power button down. It will cycle a white light for low and a red light for high, let go off the button on corresponding power setting.
Battery drain indication: Red LED will show when battery is LOW.
How long to charge: 1.5 hours.
Charge indication: White LED Indicates Above (30%)
Red LED Indicates Below (30%)
Battery Size: 800mAh
Maximum Battery Output: 15.5W
Battery Power Modes: Regular (13.5W) or Boost (15.5W)
Battery On/Off function: 3 clicks on, 3 clicks off.
EQ Pod Problems (Gurgling)
It is likely just a defective pod. Make sure you aren't overfilling the pod and flooding the coil. Fill to about 80%, let it sit, then vape. Try not to open the fill port until you have to fully refill the pod as you could potentially break the vacuum and cause a leak through the mouthpiece. More common with the original batch of EQ pods.